Risco WisDom - Scheduling Weekly Programs; Automatic Setting;Unsetting

WisDom User Manual
43
Scheduling Weekly Programs
Scheduling weekly programs enables you to automate some system
operations. This is performed by defining up to two time intervals per
day, during which the system automatically performs one of the
following functions:
♦ Automatic Setting/Unsetting, below
♦ Automatic PO Activation, page 44
♦ Limitation of User Unsetting, page 45
You can define up to 16 scheduling programs. Use the table in
Appendix D: Scheduling to define your data.
Automatic Setting/Unsetting
A setting program automatically sets and unsets the system during your
required time intervals. When defining the automatic setting/unsetting
program, you need to define the following parameters: Partition,
Setting Mode (Full/Part(Night), Time, and Label.
During the automatic activation, announcement messages will be heard
in the premises. For example, when the automatic countdown starts,
the first message will be:
"System in automatic setting process, Please exit now”
¾ To define an automatic set/unset program:
1)
From the User Functions menu, select [6] Clocks.
2)
Enter your user code followed by
.
3)
Select [5] for scheduler.
4)
Select the program index number you want to define
5)
Select [1] Set/Unset
6)
Follow the LCD display messages that will guide you
through the programming procedure.