WisDom User Manual
23
NOTE:
1. Failing to set the system due to a zone problem will be followed by the
message: "System Not Ready, Fail to Set, Check, [Zone X]".
2. Failing to set the system due to a reason other than a zone problem will be
followed by a general message prompting you to use the information
displayed on the LCD screen
3. "System Not Ready, Fail to Set, Check message Display".
4. During the exit time, a zone outside the exit route can prevent setting of the
system or can trigger an alarm (as defined by your installation company).
Part Setting
Part setting activates only perimeter detectors (as defined by your
engineer), enabling individuals to remain inside and move about the
premises even after the system is partially set.
¾ To Part set:
1)
Check the Ready LED and make sure that the system is
ready for Part (Night) setting.
2)
Enter your user code and press
. All partitions
assigned to a code will be set at Part set mode.
NOTES:
If required, and defined by your engineer, all faults in the system should
be confirmed to enable setting operation.
Scroll down the fault/s menu using the key. At the end of the list
the following question will appear: "Override flt? Y". Use the
key
to toggle the option to Y and press .
NOTE:
If defined by your engineer press for quick Part setting.
3)
If required, leave the premises and close the door. During
the Exit Delay time period, the keypad beeps, the Set
LED flashes and the Omit LED lights, indicating the
omitted interior zones.
To Next Page
Loading...
