WisDom User Manual
57
Appendix A: System Faults
The following table lists some of the possible fault conditions, their
descriptions, and recommended responses.
To check for faults in the system press
; an opening
message "System Fault" followed by a list of current fault messages
will be heard. If the list of faults is empty, the message "No System
Fault" is heard.
Fault Description LCD Display Message Response
MAIN FAULTS
Auxiliary
Failure
The panel's
Auxiliary power,
used to supply
electric current to
designated devices
(e.g. motion
detectors) has
failed.
Fault:
Aux fault
Fault:
Aux fault
"Auxiliary
Failure"
Contact your
engineer.
Bell Loop
Fault
The external bell is
disconnected
Fault:
Bell loop
Fault:
Bell loop
"Bell Loop
Fault"
Contact your
engineer.
ARC Report
Fail
Fail to
communicate with
the ARC.
Fault:
ARC 1 call error
Fault:
ARC 1 call error
"Central Station
Report Fail"
Contact your
engineer
Clock Not Set
The system's clock
has lost track of
the time and/or
date.
Fault:
System clock
Fault:
System clock
"Clock Not Set"
Set the system's
time and date, see
page 40
False Code
Fault
If enabled by your
installer, your
system will report
a false code as a
fault.
Fault:
False code P=1
Fault:
False code P=1
NOTE: P=1
refers to the
partition in
which the false
code was
entered.
"False Code,
[Partition X]"
Once the fault has
been displayed, it
will automatically
be removed from
the system.
To Next Page
Loading...
