Risco WisDom - Page 58

58 WisDom User Manual
Fault Description LCD Display Message Response
Loss of
AC Power
The commercial
power has been
interrupted; the
system will
continue to
operate on its
standby battery as
long as possible.
Fault:
AC loss
Fault:
AC loss
"AC Loss" Check the
connection of the
WisDom 's
transformer to the
mains. Ensure that
power is not
interrupted or
switched off.
Low Battery
The capacity of
the battery is low
or missing and
needs to be
recharged or
replaced.
Fault:
Low battery
Fault:
Low battery
"Low Battery
Fault”
Replace battery
Line Fault
The telephone line
is either
disconnected or
inoperative.
Fault:
Line fault
Fault:
Line fault
"Phone Line
Failure"
If all premises
telephones are
operating
properly, contact
your security
dealer.
If not, contact
your local
telephone
company.
Receiver
Jamming
Fault
An RF signal is
blocking the
channel via which
the sensors
communicate with
the control panel.
Fault:
RF Jamming
Fault:
RF Jamming
"Wireless
Receiver
Jamming"
Contact your
engineer
WIRELESS ZONES FAULTS
Zone
Loss
Fault
The system
has not
received a
signal during
a specified
time
Z=01 :LOST
ZONE 01
Z=01 :LOST
ZONE 01
"Zone Loss,
[Zone X] "
Contact your
engineer
Low Battery
Zone Fault
Wireless
transmitter low
battery has been
detected in a
certain zone.
Z=01 :LB
ZONE 01
Z=01 :LB
ZONE 01
"Low Battery,
[Zone X] "
It is recommended
to call your
engineer to
replace battery in
the relevant
wireless
transmitter.