Risco WisDom - Resetting after an Alarm

WisDom User Manual
29
Resetting after an Alarm
Your installation company can define that the reset of the system to a
Normal Operation mode will require the intervention of your ARC or
engineer. In this case, after an alarm condition, the display will show
"Call Engineer” message along with the contacting information as
defined by your engineer.
Anti Code Reset
1)
Pressing on the
key while the "Call engineer" display
is on will enter you to the Anti Code section. Press
to
enter the Anti Code option.
2)
Enter your user code and then press
.
3)
Call your ARC or engineer and quote the “RANDOM
CODE” displayed on your keypad. The ARC or engineer
will give you a return Anti-Code.
4)
Enter this Anti code followed by
and the system
will reset.
Engineer Reset
Your Alarm Receiving Center (ARC) or engineer can reset your system
remotely or locally.
To enable local reset by your engineer you may need to authorize them
as follows:
1)
Press
[7] while the "Call engineer" display is on.
2)
Enter Grand master, Master or Manager code followed by
. The following display appears:
Authorise eng.
Are you sure? N
Authorise eng.
Are you sure? N
3)
Use the
to select [Y] and press . A one hour
time window is opened for the engineer to program user
functions and be able to reset your system locally (Quick
key [*][2][]8] from the main user menu).