WisDom User Manual
33
NOTES:
Setting:
When performing forced setting, remember that it results in leaving a partition
unsecured.
Omitting a Zone:
♦ Omitting a zone results in leaving the partition to which that zone belongs
unsecured.
♦ An omitted zone’s status is automatically returned to No omit status when the
partition to which it belongs is unset.
♦ The Omit option can be disabled by your engineer, in which case it is not
announced as an option in the Operations menu.
Operating Programmable Outputs:
♦ The Programmable Output option applies to Programmable Outputs that are
defined as Follow Code. Ask your engineer for details about defining
Programmable Outputs in this way.
♦ There are 2 types of outputs which behaves differently when activated:
Latched output: Remains activated until it is deactivated.
Pulsed output: Remains activated for a predefined number of
seconds, after which it is automatically deactivated.
Ask your engineer which of your outputs are defined as latched and which are
defined as pulsed.
Changing Follow Me Numbers:
♦ Only the Grand Master, Master and Manager authority levels have permission
to change FM numbers.
♦ For more information regarding Follow Me numbers refer to page 41.
Two Way Communication
The Listen and Talk options enable you to remotely and silently listen in
to your premises in order to verify the cause of an event occurrence,
through the microphone. It also enables you to remotely talk into your
premises via the WisDom loudspeaker, for example, to guide someone
in distress.
Unlike regular phone conversations listening and talking cannot be
performed simultaneously. The WisDom allows one-way speech at a
time. You must press [1] prior to listening and [2] prior to talking in
order to be heard in the premises.
NOTE:
When entering the Listen and Talk option you have 2 minutes time out in
which to listen or talk, after each press on [1] or [2] options. After this time,
the Acknowledge menu or the Operations menu is repeated.
To Next Page
Loading...
