22 WisDom User Manual
Full Setting
Full setting prepares all of the system's intrusion detectors to activate
an alarm if violated, and is used when leaving the premises.
¾ To Full set:
1)
Check the Ready LED and make sure that the system
is ready to be set.
2)
Enter your user code and press
. All partitions
assigned to the code will be set.
NOTE:
If required and defined by your engineer, all faults in the system should
be confirmed to enable setting operation.
Scroll down the faults menu using the key. At the end of the list
the following question will appear: "Override flt? Y". Use the
key
to toggle the option to Y and press .
NOTE:
If defined by your engineer press for quick setting.
3)
Leave the premises via the authorized exit route and
close the door. The keypad beeps and the Set LED
flashes while the system counts down the Exit Delay
time period (if defined). Once the Exit Delay time
count starts the following Message will be heard:
" System is setting , Please exit now "
NOTE:
Ask your engineer for the defied exit route.
4)
When the Exit Delay time period has expired the
system is set, the Set LED lights steadily and a
confirmation message will be announced: “System is
set”
To Next Page
Loading...
