Risco WisDom - Page 25

WisDom User Manual
25
¾ To set individual partitions:
1)
Check the Ready LED and make sure that the system
is ready to be set.
2) Select the partition number to be set by pressing
followed by the partition number [1/2/3]
3)
Enter your user code and then press
.
Setting announcement message or a Fail to set message
will be heard as described in the section of Full Setting.
NOTE:
If required, all faults in the system should be confirmed to enable the
setting operation. Scroll down the list of fault/s using the key. At
the end of the list the following question will appear: « OVERIDE FLT? »
Use the key to toggle the option to Y and press .
4)
Repeat the above steps to set additional partitions.
NOTE:
If defined by your engineer press [1/2/3] for quick full
setting or [1/2/3] for quick part setting.
Examples:
To set partition 3 with code 1234 in Full mode press:
3 1-2-3-4
To set partition 3 in Quick Full mode (If defined) press:
3
To set partition 3 with code 1234 in Part mode press:
3 1-2-3-4
To set partition 3 in Quick Part set mode (if defined) press:
3