Risco WisDom - Page 31

WisDom User Manual
31
If an answering machine is not in use at the premises:
Wait until the system picks up.
After the system picks up a short tone is heard.
NOTE:
When the system picks up, all phones on the same line may be effectively
disconnected, and may not be functional at this time.
3)
Enter your 2 digit remote access code within 10 seconds. If
you wait longer than 10 seconds the system automatically
switches to MODEM mode. The sound of the connected
modem is heard, and the call must be made again, as
described in step 1.
4)
Once you have entered the remote access code the following
message is announced:
” Please enter your user code, followed by [#] ”.
5)
Enter the user code you usually enter in the WisDom
followed by [#].
NOTE:
If an invalid user code is entered the “Wrong Code” message will be heard.
If a valid user code is not entered within 10 seconds, the system hangs up,
and the call must be made again, as described in step 1.
If 3 invalid user codes are entered within 10 minutes, the system hangs up
and is then locked for 15 minutes. During this time, any calls initiated to the
system are not answered. However, it is still possible to receive event calls
from the system.
6)
After your code is accepted a system status message is
announced, followed by the Operations menu. You can now
perform the required remote operations, as described in the
subsequent sections.
TIPS:
To repeat the Status message, press
#
.
To skip further menus and go directly to your required operation, use the list
of quick key combinations on page 34.