C2 User Manual, Release 1.0.0
1.10 Removing the test print
When the test print is complete and cooled down, remove the print bed with the finished print still in place by lifting
the bed up and away from the magnets. Slowly slide the print bed out of the machine with both hands. Now, carefully
flex the print bed from several positions to help loosen the print from the print bed. Repeat this process until the most
of the print is loose from the bed. Carefully remove the print from the print bed with your hand.
Note that if the print is not coming loose after flexing the print bed, put the bed back in Robo C2 and use the provided
spatula to carefully remove the print at its borders. Then slowly work your way underneath the print until it’s loose.
Don’t force the print loose by pulling it up directly up from the print bed, since this may cause your print to break.
1.11 Using Hotspot Mode
Your printer is capable of starting If no Wi-Fi signals are available for connection, you can use Hotspot Mode to emit
a Wi-Fi signal from Robo C2 in order to connect to it wirelessly from your smart device. To access Hotspot Mode, do
the following:
1. Select “Utilities” on the home screen of the Robo C2 touch screen
2. Select “Network” from the list
3. Select “Start Hotspot Mode” from the list
14 Chapter 1. Getting Started
To Next Page
Loading...
