C2 User Manual, Release 1.0.0
1.8 Loading filament
To begin loading filament, hang your filament spool on the spool holder. Be sure to unroll at least 11”— or 30
centimeters — of filament and thread it through the base of the filament sensor block and into the filament feed tube.
Continue feeding the filament through the filament feed tube until it reaches the extruder. Then, press the extruder
lever arm down and feed the filament into the printer’s gears.
Now select UTILITIES on the touch screen.
Then select WIZARDS from the list.
10 Chapter 1. Getting Started
To Next Page
Loading...
