C2 User Manual, Release 1.0.0
Removing the prints from the platform should be done carefully so as to avoid injuries.
Risk of Burns
There is a high risk of burns while operating Robo printers as the hotend’s temperature may reach up to 300
0
C [572
0
F].
Do not touch the hotend with bare hands. Be extremely careful during maintenance and repair work of heated units.
If it is necessary to touch a heated component, use the pliers which are specially adapted for this purpose. Cooling of
components should not take less than 30 minutes.
Electromagnetic Compatibility (EMC)
Each Robo printer complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with this instruction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference - the user will be required to correct the interference at their
own expense.
The EMC test report for the Robo C2 or the Robo C2 is available on request at engineering@robo3d.com.
2 Contents
To Next Page
Loading...
