C2 User Manual, Release 1.0.0
2. Timelapse feature
• Under ‘Additional Controls’ you will find ‘Timelapse Configuration’. This will allow you to take intermittent
snapshots of your print, which will automatically put together in a timelapse video. Here, you can control the
settings such as: on/off, timelapse frame rate, and timelapse post roll. Right below this, you will find a list of all
the Finished Timelapses on that particular Robo R2.
6.6. View on-board camera + timelapse (Robo R2 only) 87
To Next Page
Loading...
