Roche 9180 - Installing the Printer Paper

Roche Diagnostics
88 Instructions for Use · Version 10.0
6 Installation and shutdown 9180 Electrolyte Analyzer
Installation
q
After the protective strip has been removed from the SnapPak, keep the SnapPak
upright to avoid spillage. Save this protective strip to seal its contents before disposal.
o At the prompt New SnapPak Installed?, press YES.
o At the prompt Are you sure?, press YES.
5. Installing the printer paper
q
The printer paper is heat-sensitive on one side only. Make sure that you insert the paper
roll correctly.
The thermal printer paper supplied by Roche Diagnostics contains an indicator strip
to alert you when the paper roll should be changed. To change the roll:
o Place a new paper roll in the paper tray and thread it into the feeder slot.
Figure 6-14
o Press the paper feed button to completely feed the paper through the printer.
Figure 6-15
q
Pressing the paper advance button once advances the printer paper 10 lines.
q
To avoid damage to the printer, do not pull the paper out of the printer.
Next, perform the initial daily maintenance.