Operating the Instrument
R&S
®
RTO
84Getting Started 1316.0833.02 ─ 10
The waveform is now active and appears in the diagram.
To select a waveform
► Choose one of the following ways:
● Tap the waveform in the waveform diagram.
● To select a channel, reference, or math waveform, press the corresponding
key.
● Tap the signal icon.
This works only if the "Click on signal icon" setting is set to "Hardkey logic", see
"To set the action on tapping the signal icon" on page 88.
Note: Zoom waveforms in zoom diagrams cannot be selected.
To minimize a waveform
► Choose on of the following ways:
● Tap the "Minimize" icon in the upper right corner of the waveform's signal label
in the signal bar.
● Drag the waveform from the diagram to the signal bar.
● Tap the signal icon.
This works only if the "Click on signal icon" setting is set to "Minimize", see "To
set the action on tapping the signal icon" on page 88.
The waveform disappears from the diagram and the minimized signal view is
shown in the signal icon.
Tip: To set the waveform back to its previous diagram immediately, use "Undo".
To arrange a waveform using the SmartGrid
You can arrange waveforms in one of the existing diagrams, or in a new diagram.
The usage of the SmartGrid is also shown in a short video that is available on the
instrument: "Tutorials > Getting Started > SmartGrid".
1. Drag the signal icon to the diagram area.
The Rohde & Schwarz SmartGrid appears and a blue area shows where the wave-
form will be placed.
2. Drop the waveform in the target area.
The waveform appears in an existing or in a new diagram and it is selected for fur-
ther actions.
Working with Waveforms
To Next Page
Loading...
