Slicer (Apply Successive Cuts to
the Sound)
By applying successive cuts to the sound, this effect
turns a conventional sound into a sound that appears
to be played as a backing phrase.This is especially
effective when applied to sustain-type sounds.
fig.7-31TEXT (#MC fig.4-39)
Timing PTN (Timing Pattern) [MULTI CTRL 1]
Select a pattern to specify the timing at which the
sound will be cut.
Range: 34 types
The lower line of the display will show the pattern
that will determine when the sound is cut. The sound
will be cut at locations without a “O” symbol.
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
By holding down [SHIFT] and rotating the [VALUE]
dial, you can select the Timing Pattern while viewing
the Accent Pattern.
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
Rate
Determines the note value unit which will be cut.
Range:
The sixteen symbols shown in the lower line of the
Timing Pattern and Accent Pattern pages correspond
to the note value that you specify. For example, if you
have selected whole notes, each of the sixteen symbols
will represent the duration of a 16th note. With this
setting, the sound will be cut as follows.
fig.7-32 (#MC fig.4-40)
Accent PTN (Accent Pattern)
[MULTI CTRL 2]
Specifies the location of the accents.
Range: 16 types
The lower line of the display will show a pattern to
indicate how accents will occur.
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
By holding down [SHIFT] as you rotate the [VALUE]
dial, you can view the Timing Pattern as you select the
Accent Pattern.
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
Accent Level
Adjusts the volume of the accents.
Range: 0–127
As this setting is increased, the accent will be more
pronounced.
Attack
Adjusts the attack speed of the sound.
Range: 1–10
As this setting is increased, the attack will become
faster.
Output Level [MULTI CTRL 3]
Adjusts the output volume from the Slicer effect.
Range: 0–127
To Next Page
Loading...
