If you would like to learn more about booster
gain settings...
☞ “Settings Common to the Entire Patch
(Common)” (p. 77)
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
FXM (Frequency Cross Modulation)
FXM (Frequency Cross Modulation) uses a specific
waveform to apply frequency modulation to the
selected waveform, creating complex overtones. This
is useful for creating dramatic sounds or sound effects.
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
FXM SW (FXM switch)
When you wish to use FXM, turn this “ON.”
FXM Color
Select one of four types of frequency modulation for
FXM to apply.
Range: 1–4
As this value is increased, the sound will become
rougher. Lower values will produce a metallic sound.
FXM Depth
Adjusts the depth of frequency modulation produced
by FXM.
Range: 1–16
As this value is increased, modulation will be applied
more deeply. As the value is decreased, modulation
depth will decrease.
Pitch-Related Settings
Using the PITCH parameters you can make settings
that affect the pitch.
Modifying the Pitch (Pitch)
Fine adjustments to the pitch (Fine
Tune)
You can adjust the pitch of each tone in 1-cent steps
(1/100th of a semitone).
1. In the REALTIME MODIFY section, press [FIL-
TER/AMP/PITCH] several times to make the
PITCH indicator light.
2. Rotate the [FINE TUNE] knob to adjust the
Fine Tune value.
fig.5-12 (=MC fig.3-12)
Range: -50–+50
Rotating the knob clockwise will raise the pitch.
Rotating it counterclockwise will lower the pitch.
Approximate adjustments to the pitch
(Coarse Tune)
Adjust the pitch of each tone in semitone steps.
1. In the REALTIME MODIFY section, press [FIL-
TER/AMP/PITCH] several times to make the
PITCH indicator light.
2. Hold down [FILTER/AMP/PITCH], and use
[INC] [DEC] or the [VALUE] dial to set the
Coarse Tune value.
fig.5-13
To Next Page
Loading...
