Roland JX-305 - Using the Keyboard; Changing the Settings of each Part; Using the Part Mixer Page to Make Changes

Using the Keyboard
1. Hold down [TRANSPOSE] and press a key
to set the transpose value.
The transpose value can be set in a range of -12–+12
semitones, above and below the C4 key.
fig.3-15 (#MC fig.2-17)
2. The transposition will be applied from the
moment that you press the keyboard.
To return to the original key, press [TRANSPOSE]
once again to make the button indicator go dark.
Changing the Settings of Each Part
The settings of a pattern (the volume and pan of each
part, etc.) can be modified in the following two ways.
Using the Part Mixer Page to
Make Changes
In the Part Mixer page, the setting values of each part
are displayed graphically. Here you can also record
the modified settings to a pattern.
☞ “Recording Part Mixer Operations” (p. 128)
fig.3-16
1. Hold down [SHIFT] and press [MIXER].
The indicator will light and the display will show the
Part Mixer page.
2. Use PART [1]–[R] to select the part for
which you wish to make settings.
3. Use PAGE [<] [>] to select the parameter
that you wish to set.
4. Use [INC] [DEC] or the [VALUE] dial to set
the value.
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
When you enter the Part Mixer page, all indicators of
[ENVELOPE/LFO1/EFFECTS], [FILTER/AMP/PITCH]
and [GRID/SHUFFLE/GROOVE] will blink, and you
can use the eight knobs of the REALTIME MODIFY
section and the QUANTIZE section to adjust the set-
tings of each part. At this time, the QUANTIZE set-
tings or REALTIME MODIFY cannot be modified by
the knobs.
fig.3-17
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
5. Press [EXIT] to exit the Part Mixer page.
Adjusting the volume of each part
(Part Level)
fig.3-18
Range: 0–127
With a setting of “127,” the volume setting of the patch
itself will be fully active.
Adjusting the pan of each part (Part Pan)
You can adjust the stereo location in the stereo output
from the OUTPUT jacks. For example, you might place
the drums and bass in the center, the piano at right,
and a pad at left.
fig.3-19
Range: L64–63R
C4
TRANSPOSE
PAGE
LOWER UPPER
SHIFT
MEASURE
TEMPO&
MIXER
CUTOFF
LEVEL
PORTA TIME
RESONANCE
PANPOT
FINE TUNE
ENVELOPE
LFO1
EFFECTS
RATE
REVERB LEVEL
FADE TIME
DELAY LEVEL
PITCH DEPTH
MULTI CTRL1
FILTER DEPTH
MULTI CTRL2
AMP DEPTH
MULTI CTRL3
GRID
SHUFFLE
GROOVE
TIMING
VELOCITY
QUANTIZEREALTIME MODIFY
ATTACK DECAY SUSTAIN RELEASE DEPTH FILTER
AMP
PITCH
12345 67 R
PART
Chapter 3. Playing Patterns
33
3