The JX-305 lets you create your own original patterns
by recording your playing on the built-in sequencer.
Broadly speaking, there are two ways to record: real-
time recording lets you record your playing and oper-
ations just as you perform, and step recording lets you
input notes one by one. The basic recording procedure
is as follows.
fig.8-1TEXT (#MC fig.10-1)
* A pattern you record is held in the temporary pattern
(TMP). If you wish to keep a pattern that you have
recorded, you must use the Pattern Write operation.
☞ “Saving Patterns You’ve Modified (Pattern
Write)” (p. 36)
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
Undo/Redo
If you are not happy with the pattern that was record-
ed, you can press the [UNDO/REDO] button to return
the data to the state before it was recorded.
☞ “Canceling the Previous Operation
(Undo/Redo)” (p. 17)
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
Recording Your Playing As
You Perform
(Real-Time Recording)
Real-time recording is a method in which your playing
on the keyboard and your controller operations are
recorded just as they occur. The JX-305 uses two types
of real-time recording, and different types of data are
recorded using different methods.
Loop Mix recording
Recording will take place repeatedly from the begin-
ning to the end of the pattern. If data was already
recorded in the pattern from a previous pass, it will
remain, and the newly recorded data will be combined
with it. Note messages are recorded using this
method.
fig.8-2TEXT (=MC fig.10-2)
Loop Replace recording
Recording will take place repeatedly from the begin-
ning to the end of the pattern. If data was already
recorded in the pattern from a previous pass, it will be
erased and replaced by the recording. Controller oper-
ations, etc. are recorded using this method.
fig.8-3TEXT (=MC fig.10-3)
Recording Procedure
Before you begin, select the pattern that will be record-
ed. If you wish to record a new pattern, select TMP
(the temporary pattern). If you wish to re-record a pre-
set pattern, etc., select that pattern.
* If something has already been recorded in the temporary
pattern, use the Pattern Initialize operation to clear any
musical data from the temporary pattern (p. 38).
1. Press [REC].
The indicator will blink, and the Recording Standby
page will appear.
To Next Page
Loading...
