Output Pan
Specifies the stereo location of the output from the
Phaser effect.
Range: L64–63R
Output Level [MULTI CTRL 3]
Specifies the output volume of the Phaser effect.
Range: 0–127
Chorus (Add Spaciousness and
Depth to the Sound)
This effect creates an impression of multiple sound
sources in unison (Chorus effect), giving spaciousness
and depth to the sound.
fig.7-36 (#MC fig.4-46)
Pre Delay (Pre Delay Time)
Specifies the time from the original sound until when
the chorus sound is heard.
Range: 0.0–100
Rate [MULTI CTRL 2]
Specifies the frequency of modulation.
Range: 0.1–10.0
2MES 3MES 4MES 8MES 16MES
If a note value or measure is selected as the value of
this parameter, the Rate will synchronize with the
tempo of the pattern at intervals of the specified note
value or measure.
Depth [MULTI CTRL 1]
Specifies the depth of modulation.
Range: 0–127
Phase
Adjusts the spaciousness of the sound.
Range: 0–180
As this setting is increased, the sound will spread
more toward left and right.
Filter Type
Determines the type of filter that will be applied to the
chorus sound.
Available Settings:
OFF : A filter will not be used.
LPF : The frequency range above the cutoff frequency
will be cut.
HPF : The frequency range below the cutoff frequency
will be cut.
Cutoff (Cutoff Frequency)
Specifies the cutoff frequency of the filter.
Range: 200–8000 (Hz)
Balance (Effect Balance)
Adjusts the volume balance between the original
sound and the chorus sound.
Range: D100:0E–D0:100E
With a setting of “D100:0E,” no chorus sound will be
output.
Output Level [MULTI CTRL 3]
Specifies the output volume from the stereo chorus.
Range: 0–127
To Next Page
Loading...
