☞ “Using Memory Cards” (p. 159)
4. Press [PART SELECT] once again.
The [PART SELECT] indicator goes out, and you can
now use BANK and NUMBER [1]–[8] to select a
rhythm set.
5. Press BANK [1]–[4] to select the bank.
6. Press NUMBER [1]–[8] to select the number.
Play the keyboard, and the selected rhythm set will be
heard. Each key will play a different percussion instru-
ment sound.
* If the [PART SELECT] or [PART MUTE] indicators in
the PART section are lit, steps 5 and 6 cannot be per-
formed. In this case, press [PART SELECT] or [PART
MUTE] to make the indicator go dark.
* Instead of specifying the group/bank/number, you can
also use [INC] [DEC] or the [VALUE] dial to select a
patch.
* Depending on the group and bank, it may not be possible
to select all numbers [1]–[8].
To view a list of available rhythm sets...
☞ “Preset Rhythm Set List” (p. 195)
Listening to Sound Processed
by the Effects (Audition)
The JX-305 contains three effects units. Thirty-two dif-
ferent settings for these three effects units, together
with a patch/rhythm set are provided as Effect
Templates (16 for patches, 16 for rhythm sets). The
Audition function lets you use these effects templates
to listen to the sound of a patch as it is processed by
the effects units. Effect templates are assigned to the
sixteen BANK and NUMBER [1]–[8] buttons.
fig.2-3-1Åi8-8BUTTONÅj
1. Use [PART SELECT] and PART [1]–[R] to spec-
ify whether you will use an effects tem-
plate for a patch or for a rhythm set.
For parts 1–7, use one of the patch effects templates.
For part R, use one of the rhythm set effects templates.
2. Hold down [SHIFT] and press [AUDITION].
The indicator will begin blinking, and the display will
show the effect type and patch name for the currently
selected effects template.
fig.2-3-2ÅiBUTTON&LCDÅj
* It is not possible to enter the audition function while a
pattern is playing back.
3. Use BANK and NUMBER [1]–[8] to select an
effects template.
To see the effects templates that are available...
☞ “Effects Template List” (p. 203)
4. You can use [INC] [DEC] or the [VALUE] dial
to change only the patch without changing
the effects settings.
If you wish to modify the effects settings, use the pro-
cedure given in “Applying Effects to the Sound
(Effects)” (p. 101).
5. To exit the Audition function, press [EXIT].
* When you select a effects template, the setup parameters
of the temporary pattern will change to the settings of the
template.
* It is not possible to select the effects template while a pat-
tern is playing back.
* If you wish to keep the modified effects settings, it is not
possible to rewrite the template, but you can save the data
to a pattern.
☞ “Saving Patterns You’ve Modified (Pattern
Write)” (p. 36)
* A noise-like sound may be heard when the NUMBER [5]
template for rhythm sets is selected, but this is not a mal-
function.
To Next Page
Loading...
