Controlling the JX-305 from an
External MIDI Device
Playing the JX-305 from an External
MIDI Keyboard
When the Remote Keyboard Switch is “ON”
fig.14-2(#MC fig.16-2)
By changing the current part on the JX-305, you can
change the part that will sound. The transmit channel
of the external MIDI keyboard does not matter.
When the Remote Keyboard Switch is “OFF”
fig.14-3(#MC fig.16-3)
Set the transmit channel of the external MIDI key-
board to match the receive channel of the JX-305 that
you wish to play. For example, if you wish to play part
2, set the transmit channel of the external MIDI key-
board to “2” since the receive channel of part 2 is “2.”
☞ “Using an External MIDI Keyboard in Place
of the Keyboard of the JX-305 (Remote
Keyboard Switch)” (p. 165)
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
Selecting patches from an external MIDI device
By transmitting control change Bank Select messages
(CC#0, CC#32) and Program Change messages (PC)
from an external MIDI device to the JX-305, you can
change the patch (rhythm set) of each part. At this
time, the Receive Program Change Switch and the
Receive Bank Select Switch must be turned ON (p.
166). For details on how bank select and program
change messages are transmitted from your external
MIDI device, refer to the owner’s manual for your
device.
If you would like to know how the incoming
bank select and program change messages
correspond to each patch (rhythm set), refer to:
☞ “Preset Patch List” (p. 190)
☞ “Preset Rhythm Set List” (p. 195)
☞ “MIDI Implementation” (p. 236)
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
To Next Page
Loading...
