5. Use [INC] [DEC] or the [VALUE] dial to select
the save destination bank and number.
You can also use the BANK and NUMBER [1]–[8] but-
tons to select the save destination bank and number.
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
At this time, you can press [UNDO/REDO] to check
the name and sound of the patch that is currently in
the save destination number. After you have found a
patch that you do not mind overwriting, press
[UNDO/REDO] once again to return to the previous
display.
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
6. Press PAGE [>].
The cursor will move to the beginning of the second
line in the display.
fig.5-85
7. Assign a name to the patch.
Use [INC] [DEC] or the [VALUE] dial to specify the
character.
The following characters can be selected:
Space, A–Z, a–z, 0–9, ! “ # $ % & ‘ ( ) * +, - . / : ; < = > ?
@ [ ¥ ] ^ _ ` {|}
8. Repeat steps 6–7 to input the name.
By pressing PAGE [<] you can move the cursor back
toward the left.
* A name of up to 12 characters can be input.
9. Press [ENTER].
The confirmation screen will appear in the display.
If you decide to cancel the operation, press [EXIT].
fig.5-86
10. Press [ENTER] once again.
fig.0-005
The Patch Write operation will be carried out, then the
normal display will reappear.
The patch has now been saved.
Copying and Initializing Settings
Patch Tone Copy
This operation copies the settings of a tone in a patch
to the specified tone of the currently-selected patch.
1. Select any part 1–7 as the current part.
2. Press [PATCH] to access the patch select
page.
3. Press [UTILITY].
The indicator will light.
4. Press PAGE [<] [>] several times to select
“COPY,” and press [ENTER].
5. Select “TONE,” and press [ENTER].
The display will show the copy source patch, the copy
source tone and the copy destination tone.
fig.5-88TEXT
6. Use [INC] [DEC] or the [VALUE] dial to speci-
fy the copy source patch, the copy source
tone and the copy destination tone.
You can use PAGE [<] [>] to move the cursor.
You can also use the BANK and NUMBER [1]–[8] but-
tons to select the copy source patch.
7. Press [ENTER].
The confirmation screen will appear in the display.
If you decide to cancel the operation, press [EXIT].
fig.5-89
8. Press [ENTER] once again.
fig.0-005
The Patch Tone Copy operation will be carried out,
then the normal display will reappear.
If you wish to save the patch that you copied, use the
Patch Write operation.
☞ “Saving Patches You’ve Created (Patch
Write)” (p. 82)
To Next Page
Loading...
