* If the pattern is stopped, the phrase will play back imme-
diately, regardless of this setting.
Synchronizing Arpeggios to the
Pattern (Arpeggio Sync)
You can specify whether or not arpeggios will be syn-
chronized to the pattern playback.
Range: OFF, ON
With the factory settings, this will be “ON.” If you do
not want arpeggios to be synchronized to the pattern
playback, turn Arpeggio Sync “OFF.”
Calculating a Checksum
Automatically (Auto Checksum)
This specifies whether or not the checksum will be cal-
culated automatically when you use the Microscope
page to input a system exclusive message.
Range: OFF, ON
With the factory settings this will be “ON.” If you do
not want the checksum to be calculated automatically,
turn this “OFF.”
Specifying the Resolution of the
Tap Tempo (Tap Resolution)
This specifies the basic note value that will be used
when the Switch pedal is used to modify the tempo.
Range:
When you press the Switch pedal, the tempo will be
changed to intervals of the specified note value.
Tuning and Sound Generator
Related Settings
1. Press [EDIT].
The indicator will light and the display will show the
Edit page.
2. Press BANK [8] (SETUP).
The SETUP setting page will appear.
3. Use PAGE [<] [>] to select parameters, and
use [INC] [DEC] or the [VALUE] dial to set
each parameter.
fig.13-1(#MC fig.15-1)
To exit the setting page, press [EXIT].
Adjusting the Display Contrast
(LCD Contrast)
This adjusts the contrast (brightness) of the LCD dis-
play. Increasing this value will increase the contrast of
the display.
Range: 1–16
Adjusting the Overall Tuning
(Master Tune)
This adjusts the tuning of the JX-305’s sound genera-
tor. The display shows the frequency of the A4 note.
Range: 427.4–440.0–452.6 Hz
Tuning Each Note (Scale Tune)
By modifying the tuning of each of the 12 notes from C
to B, you can play using a variety of temperaments.
Scale Tune SW (Scale Tune Switch)
Turn this ON when you wish to use the Scale Tune
function.
Range: OFF, ON
To Next Page
Loading...
