5. Press PAGE [>].
The cursor will move to the beginning of the second
line of the display.
fig.11-19
6. Assign a name to the song.
Use [INC] [DEC] or the [VALUE] dial to specify char-
acters.
The following characters can be selected.
Space, A–Z, a–z, 0–9, ! “ # $ % & ‘ ( ) * + , - . / : ; < = > ?
@ [ ¥ ] ^ _ ` {|}
7. Repeat steps 5–6 to enter the name.
To move the cursor back toward the left, press PAGE
[<].
8. Press [ENTER].
The confirmation screen will appear in the display.
To cancel the operation, pres [EXIT].
fig.11-20
9. Press [ENTER] once again.
fig.0-5
The Song Write operation will be carried out, and the
normal display will reappear.
The song has now been saved.
Initializing Settings
(Song Initialize)
This initializes the song to a state in which no patterns
are recorded.
1. Make sure that the song is stopped.
2. Press [PTN/SONG] to access the song select
page.
3. Select the song that you wish to initialize.
4. Press [UTILITY].
The indicator will light.
5. Press PAGE [<] [>] several times to select
“INITIALIZE,” and press [ENTER].
6. Select “SONG,” and press [ENTER].
The following display will appear.
fig.11-21
7. Press [ENTER].
fig.0-5
The Song Initialize operation will be carried out, then
the normal display will reappear.
Chapter 11. Connecting Patterns in Playback Order to Create a Song
158
11
To Next Page
Loading...
