Time1–4 (Filter Envelope Time 1–4)
Specifies the time until the next cutoff frequency is
reached. You can set the four values Time1–4.
Range: 0–127
Higher settings will lengthen the time until the next
cutoff frequency is reached.
* The front panel [ATTACK] (Attack Time) corresponds to
Time 1, [DECAY] (Decay Time) to Time3, and
[RELEASE] (Release Time)to Time4.
Level1–4 (Filter Envelope Level 1–4)
Specifies the cutoff frequency at each level. You can set
the four values Level 1–4.
Range: 0–127
Higher settings will also raise the cutoff frequency.
* The front panel [SUSTAIN] (Sustain Level) corresponds
to Level3.
Settings Related to Volume
and Pan (Amplifier)
The AMP (amplifier) parameters contain settings relat-
ed to the volume and stereo location of the sound.
Adjusting the Volume and Pan
(Amplifier)
Adjusting the volume of each rhythm
tone (Rhythm Tone Level)
This setting adjusts the volume of each rhythm tone.
This is used mainly to adjust the volume balance
between rhythm tones.
1. In the REALTIME MODIFY section, press [FIL-
TER/AMP/PITCH] several times to make the
AMP indicator light.
2. Rotate the [LEVEL] knob to adjust the
Rhythm Tone Level setting.
fig.6-22 (#MC fig.3-118)
Range: 0–127
As the knob is rotated further clockwise, the volume
will increase. As it is rotated counterclockwise, the
volume will decrease.
* The overall volume of the entire rhythm set can be modi-
fied and memorized for each pattern as the Setup parame-
ter Part Level. The Rhythm Tone Level setting will be
multiplied by this value.
☞ “Adjusting the volume of each part (Part
Level)” (p. 33)
Adjusting the pan for each rhythm
tone (Rhythm Tone Pan)
This parameter sets the stereo location for each
rhythm tone.
1. In the REALTIME MODIFY section, press [FIL-
TER/AMP/PITCH] several times to make the
AMP indicator light.
2. Rotate the [PANPOT] knob to set the
Rhythm Tone Pan value.
fig.6-23 (#MC fig.3-119)
Range: L64–63R
As the knob is rotated further clockwise, the stereo
location will shift toward the right. As it is rotated
counterclockwise, the location will shift toward the
left.
* The pan of the overall rhythm set can be modified and set
for each pattern by the Setup parameter Part Pan. The
Rhythm Tone Pan value will be added to this setting.
☞ “Adjusting the pan of each part (Part Pan)”
(p. 33)
To Next Page
Loading...
