Specifying the Arpeggio Style at
Power-On
(Default Arpeggio Style)
Specify the arpeggio style which will be selected when
the power is turned on.
Range: 1/4, 1/6, 1/8, 1/12, 1/16, 1/32, PORTAMENTO
A, B, GLISSANDO, SEQUENCE A–D,
ECHO, SYN BASS, HEAVY SLAP, LIGHT
SLAP, WALK BASS, RHYTHM GTR 1–5,
3 FINGER, STRUMMING GTR, PIANO
BACKING, CLAVI CHORD, WALTZ,
SWING WALTZ, REGGAE, PERCUSSION,
HARP, SHAMISEN, BOUND BALL, RAN-
DOM, BOSSA NOVA, SALSA, MANBO,
LATIN PERCUSION, SAMBA, TANGO,
HOUSE, LIMITLESS, USER STYLE 1–10
* When the power is turned on, the arpeggiator switch will
be off.
Restoring the Factory
Settings (Factory Preset)
The sound settings and pattern data stored in the JX-
305 can be restored to the factory set condition.
* If your JX-305 contains important data, use the Bulk
Dump procedure to save the data on an external MIDI
sequencer etc., or use the User Backup procedure to save
the data on a memory card.
☞ “Saving Pattern and Patch Data on an
External Sequencer (Bulk Dump)” (p. 176)
☞ “Saving All Internal Settings to a Card (User
Backup)” (p. 160)
1. Press [UTILITY].
The indicator will light.
2. Press PAGE [<] [>] several times to select
“FACTORY PRESET,” and press [ENTER].
3. Use PAGE [<] [>] to select the item that you
wish to restore to the factory set condition.
The following three items can be selected.
ALL: All internal settings will be restored to the
factory settings.
PATCH: The user patches of internal memory will be
restored to the factory settings.
SYSTEM: The System settings will be restored to their
factory settings.
fig.13-8
4. Press [ENTER].
The execute page will appear in the display.
If you wish to cancel the operation, press [EXIT].
fig.0-004
5. Press [ENTER], and the Factory Preset oper-
ation will be executed.
While this is being executed, the following display will
appear.
fig.0-005
When the Factory Preset operation is completed, the
normal display will automatically reappear.
* If you select “ALL” and execute, approximately one
minute will be required for the operation to be completed.
Once the Factory Preset operation has been executed,
never turn off the power until the normal display has
reappeared.
Chapter 13. Setting the Operating Environment of the JX-305 (System)
170
13
To Next Page
Loading...
