Moving Musical Data (Move Event)
1. In the Microscope page, rotate the [VALUE]
dial to access the musical data that you
wish to move.
2. Hold down [SHIFT] and [REC], and rotate
the [VALUE] dial to move the data.
While you hold down the buttons, the display will
indicate the position to which the data is being moved.
fig.9-76 (#MC fig.10-78)
Hiding Unwanted Musical Data
(View Filter)
If a large amount of musical data has been recorded in
a pattern, it may be difficult for you to find the data
you are looking for if all types of data are displayed.
In such cases, you can use the View Filter to specify
the types of musical data that will be displayed. Since
you can specify that only certain MIDI messages will
be displayed, this lets you rapidly find the data that
you are looking for.
1. In the Microscope page, press NUMBER [8]
(VIEW FILTER).
The View Filter page will appear in the display.
fig.9-77 (#MC fig.10-79)
2. Press PAGE [<] [>] to select the type of
musical data.
Note: Note
PC: Program change
CC: Control change
PchBend: Pitch bend
PA: Polyphonic aftertouch
ChAfter: Channel aftertouch
Sys-Ex: System exclusive
Tempo: Tempo
Mute: Mute
3. Use [INC] [DEC] or the [VALUE] dial to turn
off the display of musical data that you do
not need to view.
4. When you finish making settings, press
[EXIT] to exit the page.
Data that you turned off will no longer be displayed in
the Microscope page.
To Next Page
Loading...
