The indicator will light, and the display will graphical-
ly show the current setting of each RPS part.
3. Press PAGE [<] [>] several times to select
the parameter that you wish to modify.
fig.4-10 (#MC fig.6-8)
4. Press a note to which a phrase has been
registered to switch the part shown in the
display.
If you press any note C#2–G#2, the settings of RPS
parts 1–8 will be graphically displayed.
If you press any note A2–E3, the settings of RPS parts
9–16 will be graphically displayed.
The right side of the display will indicate the current
setting value of the selected RPS part.
5. Use the eight knobs of the REALTIME MODI-
FY section and the QUANTIZE section to
adjust the settings of each RPS part.
fig.4-10-1
* Keys to which a rhythm part phrase is assigned will
reflect the rhythm part settings of the currently selected
pattern. For example, if RPS phrases using the rhythm
part are assigned to keys C#2 and D2, modifying the vol-
ume setting or rhythm set of C#2 key will cause the set-
tings of D2 key and the rhythm part of the selected pat-
tern to change in the same way.
Changing the Patch of Each RPS
Part
You can change the sound which plays each RPS part,
so that the phrase assigned to each key will be heard
with a different sound.
1. Hold down [RPS] and press [PATCH].
The indicator will light, and the following display will
appear.
fig.4-11 (#MC fig.6-9)
2. Press the note for the phrase whose patch
you wish to change to select the RPS part.
The display will indicate the patch of the selected RPS
part.
3. Use [INC] [DEC] or the [VALUE] dial to select
the desired patch.
You can also use the GROUP section [PRESET/USER/
CARD], [<PREV] [NEXT>] and BANK and NUMBER
[1]–[8] buttons to select a patch.
* If you change the rhythm set of a key to which a rhythm
part phrase is registered, the rhythm set of the currently
selected pattern will change in the same way.
To Next Page
Loading...
