When this setting is at “0,” the setting of the patch
itself will be unaffected.
* Pan is specified independently for each tone of a patch (or
each rhythm tone of a rhythm set). Modifying the Part
Pan applies a relative change to the overall panning of the
patch or rhythm set.
* For some patches, a small amount of sound may be heard
from the opposite speaker even if the pan is set to full left
or full right. Also, the Part Pan setting will have no effect
in the following cases.
• When monaural connections are used
• Tones/rhythm tones for which Random Pan is ON
☞ “Causing pan to change randomly (Random
Pan Switch)” (p. 67)
• Patches/rhythm tones to which a mono-output
Multi Effects (spectrum, overdrive, distortion, noise
generator, phonograph, limiter, phaser) is applied
The same applies for the Lo-Fi or Radio Tuning
effects if the output setting of them is set to MONO.
☞ “Applying Various Effects to the Sound
(Multi-Effects)” (p. 106)
Adjusting the pitch of each part (Part
Key Shift)
You can adjust the pitch of the sound of each part.
fig.3-20
Range: -48–+48 semitones
When the value is “0,” the original pitch of the patch
itself will be used without change.
If you hold down [SHIFT] and change the value using
[INC] [DEC] or the [VALUE] dial, the pitch will
change in units of an octave (12 semitones).
Adjusting the reverb volume for each
part (Part Reverb Level)
You can adjust the volume of the reverberation for
each part.
fig.3-21
Range: 0–127
☞ “Adding Reverberation to the Sound
(Reverb)” (p. 102)
Adjusting the delay volume for each
part (Part Delay Level)
You can adjust the volume of the delay sound for each
part.
fig.3-22
Range: 0–127
☞ “Adding an Echo to the Sound (Delay)” (p.
103)
Applying multi-effects to each part
(Part Multi-Effects Switch)
For each part you can switch multi-effects on/off.
fig.3-23
Range:
OFF: Multi-effects will not be applied.
RHY: The sound will be output according to the
Rhythm Tone Multi-Effects Switch, Rhythm
Tone Reverb Level, and Rhythm Tone Delay
Level settings of the selected rhythm set (only
for the rhythm part) (p. 97).
ON: Multi-effects will be applied.
☞ “Applying Various Effects to the Sound
(Multi-Effects)” (p. 106)
Using the Editing Pages to Make
Changes
In the editing pages you can make settings for all part
parameters, but cannot record the modified settings to
a pattern.
1. Press [EDIT].
The indicator will light and the display will show the
Edit page.
2. Press BANK [3] (PART).
The part setting page will appear.
3. Use [PART SELECT] and PART[1]–[R] to select
the part.
4. Use PAGE [<] [>] to switch parameters.
5. Use [INC] [DEC] or the [VALUE] dial to make
settings.
fig.3-24
Chapter 3. Playing Patterns
34
3
To Next Page
Loading...
