Roland JX-305 - Error Message List

If an incorrect operation has been performed or if pro-
cessing could not be carried out as specified, an error
message will appear. Refer to this list and take the
appropriate action.
fig.15-1
• There is a problem with the MIDI cable connec-
tions.
☞ Make sure that MIDI cables have not been pulled
out or broken (Quick Start; p. 3).
fig.15-2
• More MIDI messages were received at once than
the JX-305 was able to process.
☞ Reduce the amount of MIDI messages that are
being transmitted to the JX-305.
fig.15-3
• More recording data was received at once than the
JX-305 was able to process.
☞ Reduce the amount of recording data that is being
transmitted to the JX-305.
fig.15-4
• The checksum value of the received system exclu-
sive message is incorrect.
☞ Correct the checksum value.
fig.15-5
• Since the maximum number of notes that can be
recorded in a single pattern has been reached, fur-
ther pattern recording is not possible.
☞ Delete unneeded data from the pattern that you are
recording (p. 141).
fig.15-6
• Since the maximum number of patterns that can
be registered in a single song has been reached,
further song recording is not possible.
☞ A maximum of 50 patterns can be registered in a
single song. No further patterns can be registered.
fig.15-7
• Since there is insufficient user memory, the pat-
tern cannot be saved.
☞ Either initialize an unneeded pattern, or save the
data to a memory card.
fig.15-8
• Since there is insufficient card memory capacity,
the pattern cannot be saved.
☞ Either initialize an unneeded pattern, or save the
data to internal memory.
fig.15-8
• Since a different time signature is set for the copy
source and copy destination patterns, the pattern
copy is not possible.
☞ The pattern copy operation can only be used for
patterns with the same time signature.
fig.15-9
• Since there are two or more un-muted parts, the
phrase cannot be assigned to an RPS set.
☞ Decide on one part in the phrase that you wish to
register, and mute all other parts (p. 49).
• The TMP pattern cannot be registered in a PTN
SET.
☞ First save the pattern as a User pattern, and then
register it in the PTN SET.
fig.15-10
Error Message List
185