• Quantize is not selected.
☞ Press [GRID/SHUFFLE/GROOVE] to select the
quantization that you wish to use (p. 40).
fig.15-11
• Since a write protect sticker is affixed to the mem-
ory card, data cannot be saved to the card bank.
☞ Remove the write protect sticker from the memory
card (p. 159).
fig.15-12
• Since the pattern contains no musical data, it can-
not be played back or modified.
fig.15-13
• Cannot undo.
fig.15-14
• The card manufacturer/model is not specified for
use with the JX-305.
☞ Use a specified card (p. 159).
• The card has not been formatted for the JX-305.
☞ Format the card (p. 159).
• It is possible that the contents of the card have
been damaged.
☞ Format the card (p. 159).
• The card does not contain JX-305 data.
☞ Use a card that contains JX-305 data.
fig.15-15
• No card is inserted.
☞ Turn off the power, and insert a card (p. 159).
fig.15-15-1
• There is a defective block in the copy destination
card.
☞ The memory card has reached the end of its lifes-
pan. Please purchase a new memory card.
fig.15-16
• It is possible that the contents of internal memory
have been damaged.
☞ Try executing the Factory Preset operation (Quick
Start, p. 6). If this does not resolve the problem,
contact a nearby Roland service center.
fig.15-20
• Since card memory is insufficient, it is not possi-
ble to create a backup file.
☞ Initialize unneeded patterns.
fig.15-22
• A card other than the copy source was inserted.
☞ Insert the copy source card (p. 161).
fig.15-23
• A card other than the copy destination was insert-
ed.
☞ Insert the copy destination card (p. 161).
fig.15-24
• Since a Preset pattern is selected, it is not possible
to initialize.
186
To Next Page
Loading...
