Here you can make settings that affect the operation of
the entire JX-305, such as tuning and the synchroniza-
tion method. The settings of the various System para-
meters are remembered even while the power is
turned off.
* It is not possible to access the various System setting
pages while a pattern or song is playing back.
Controller-Related Settings
1. Press [EDIT].
The indicator will light and the display will show the
Edit page.
2. Press BANK [5] (CONTROLLER).
The display will show the CONTROLLER setting
page.
3.
Use PAGE [<] [>] to select parameters, and
use [INC] [DEC] or the [VALUE] dial to set each
parameter.
fig.13-3
To exit the setting page, press [EXIT].
Changing the Loudness of Notes
Played on the Keyboard
(Keyboard Velocity)
When you play notes on the keyboard, the loudness of
each note is affected by the force (velocity) at which
you strike the note. If you want the velocity value of
each note to depend on how strongly you play the
keyboard, set this parameter to REAL. If you want
each note to have a fixed velocity regardless of how
strongly you play the keyboard, set this parameter to
the desired value.
Range: REAL, 1–127
Setting Aftertouch Sensitivity
(Aftertouch Sens)
You can specify aftertouch sensitivity.
Range: 0–100
Higher values allow aftertouch to be easier applied.
Default setting is 100.
As this value is increased, notes played from the key-
board will be stronger.
Specifying How the Pedal Will
Function
Hld Pdl Pol (Hold Pedal Polarity)
Select the polarity of the Hold pedal.
Range: STANDARD, REVERSE
If you are using a pedal with inverted polarity (so the
pedal functions in a way opposite from what you
expect), select “REVERSE.”
C-Pdl Assgn (Control Pedal Assign)
Specify the function of the pedal (control pedal) con-
nected to the CONTROL PEDAL jack.
Range:
CC01–CC95: Controller Number 1–95
(except 6, 32, 38)
PITCH BEND UP: Pitch Bend Up
PITCH BEND DOWN: Pitch Bend Down
AFTERTOUCH: Aftertouch
C-Pdl Pol (Control Pedal Polarity)
Select the polarity of the Control pedal.
Range: STANDARD, REVERSE
If you are using a pedal with inverted polarity (so the
pedal functions in a way opposite from what you
expect), select “REVERSE.”
To Next Page
Loading...
