fig.12-17 (#MC fig.14-11)
3. Insert the copy source memory card into
the memory card slot.
The following display will appear.
fig.0-5 (#MC fig.2-36)
4. After a time, the following display will
appear, so remove the copy source card
and insert the copy destination card.
fig.12-19 (#MC fig.14-13)
The following display will appear.
fig.0-5 (#MC fig.2-36)
5. After a time, the following display will
appear, so repeat steps 3–4.
fig.12-20 (#MC fig.14-15)
6. When the Card Duplicate operation has
been completed, the following display will
appear.
fig.12-22 (#MC fig.14-16)
To exit the Card Duplicate page, press [UTILITY].
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
Installing the card protector
The JX-305 provides a card protector to prevent theft
of the memory card. To install the card protector, use
the following procedure.
1. Use a screwdriver to remove both screws
that are at either side of the memory card
slot.
2. Insert the memory card into the memory
card slot.
3. Use the screws to fasten the card protector
as shown below.
fig.12-23 (#MC fig.14-17)
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
Using MC-505 cards
The JX-305 can read patch, rhythm set and pattern
data from a memory card that has been written on the
MC-505.
Conversely, patch, rhythm set and pattern data that
was written by the JX-305 to a memory card can also
be read by the MC-505.
* Data which uses waves (C:001–C:131) or patches
(P:I11–P:J88) that were added on the JX-305 cannot be
read correctly by the MC-505.
* It is not possible to read a backup file that was written by
the MC-505.
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
To Next Page
Loading...
