Causing a Phrase to Continue
Playing (RPS Hold)
Normally, the phrase will stop playing when you take
your finger off the note. However when the RPS Hold
function is used, the phrase will continue playing even
after you release the note.
There are two ways to hold an RPS phrase.
Holding all phrases
1. Hold down [HOLD] and press [RPS].
The indicator will blink.
fig.4-4
2. Press a note to play back a phrase.
The phrase will continue playing back even after you
release the note.
You can press additional notes while the indicator is
blinking, and their phrases will be held.
3. To stop playback of a phrase, hold down
the note of the phrase that you wish to
stop, and press the note at the far left (RPS
STOP).
4. To stop playback of all phrases, either
press the note at the far left (RPS STOP), or
once again press [RPS] and [HOLD] simulta-
neously.
Holding a specific phrases
1. Press a note to play back the phrase that
you wish to hold.
2. While continuing to press the note, press
[HOLD].
The phrase will continue playing even after you
release the note.
If you release [HOLD] and then press and release
other notes, their phrases will not be held.
fig.4-5
3. To stop playback of a phrase, hold down
the note to which that phrase is assigned,
and press the note at the far left (RPS
STOP).
fig.4-5-1
4. To stop playback of all phrases, press the
note at the far left (RPS STOP).
fig.4-5-2
Alternatively, if you connect a pedal switch or foot
switch (optional) and set the System setting “Switch
Pedal Assign” to “RPS HOLD,” the pedal switch can
be used to hold RPS phrases in the same way as with
the [HOLD] button (p. 46).
Assigning Phrases to the
Keyboard
The phrases that are assigned to an RPS set can be re-
assigned whenever you wish. You will find it conve-
nient to assign your favorite or frequently-used phras-
es in one RPS set. As an example, here’s how to assign
the phrase of part 2 of P:A12 in an RPS set.
First we must select the RPS set in which we will
assign the phrase.
1. Select the RPS set to which you wish to
assign the phrase.
2. Select pattern P:A12.
3. Use [PART MUTE] and the PART buttons
[1]–[R] to mute all parts except for part 2.
* You can quickly mute all parts except for part 2 by hold-
ing [PART MUTE] and pressing PART [2].
fig.4-6 (#MC fig.6-4)
4. Make sure that the [RPS] indicator is lit.
To Next Page
Loading...
