Pan Depth (LFO1/LFO2 Pan Depth)
Adjusts the effect that the LFO will have on pan
(stereo location).
Range: -63–+63
Setting values toward the positive (+) side of 0 will
produce a greater change in panning. Setting values
toward the negative (-) side of 0 will invert the wave-
form to change the pan in the opposite direction.
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
By giving two tones the same rate setting and setting
their Pitch Depth to “+30” and “-30” respectively to
apply opposite-phase LFO, you can create a vibrato
effect in which the pitches change in opposite direc-
tions.
fig.5-65 (#MC fig.3-66)
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
Specifying the Parameters
That Will Be Modified by
Each Controller (Control)
These settings determine how the controllers (pitch
bend lever, modulation lever, aftertouch) will control
the patch parameters etc. of the JX-305.
These settings are divided into three groups, depend-
ing on the controller involved.
Modulation Lever
This controller is used to apply vibrato or add various
effects.
Settings for it are made using the MOD (Modulation)
parameters.
Pitch Bend Lever
This controller is normally used to control the pitch.
Settings for it are made using the BEND (Pitch Bend)
parameters.
Aftertouch
Aftertouch is a function which produces various types
of change in the sound as you apply pressure to the
keyboard after playing a note.
Settings for it are made using the AFT (Aftertouch)
parameters.
1. Press NUMBER [7] (CONTROL).
The display will show the CONTROL setting page.
2. Use PAGE [<] [>] to switch parameters and
edit them.
fig.5-66
Adjusting the Range of Pitch
Bend (Bend Range)
Bend Up/Down
Specifies the amount of pitch change (in semitone
units) that will occur when the pitch bend lever is
operated. You can make independent settings for
movement to the right (raising the pitch) and left (low-
ering the pitch).
Available settings:
Bend Range Up : 0 – +12
Bend Range Down : 0 – -48
Higher settings will result in a greater pitch change
when the pitch bend lever is moved to the left or right.
For example, if Bend Range Up is set to “+12,” the
pitch will rise one octave when the pitch bend lever is
moved to the right-most position.
To Next Page
Loading...
