Key Sync (LFO1/LFO2 Key Sync)
This parameter synchronizes the LFO cycle to the tim-
ing at which the keyboard is played.
Available settings:
ON : The LFO cycle will begin when the keyboard is
played.
OFF : The same LFO waveform will be output regard-
less of the timing at which the keyboard is
played.
fig.5-62TEXT (=MC fig.3-63)
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
When Key Sync is on, the LFO waveform will begin
for each note when it is played, producing a spacious
sound with a sense of movement. When Key Sync is
off, a single LFO waveform will be applied to all notes,
producing a unified sound. When you wish to empha-
size the effect (vibrato etc.), you may want to turn this
parameter off. Also, when Tempo Sync is on, leaving
Key Sync off will allow you to synchronize precisely
to the tempo of the pattern.
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
Fade Mode (LFO1/LFO2 Fade Mode)
Select the way in which the LFO effect will be applied.
Available settings:
OnI (On-In): The effect will be applied gradual-
ly, after the keyboard is played.
OnO (On-OUT): The effect will be applied immedi-
ately when the keyboard is played,
and will gradually disappear.
OfI (Off-In): The effect will be applied gradual-
ly, starting when the keyboard is
released.
OfO (Off-Out): The effect will be applied while the
keyboard remains played, and will
gradually disappear after it is
released.
fig.5-63TEXT (=MC fig.3-64)
Delay Time (LFO1/LFO2 Delay Time)
Depending on the Fade Mode setting, specify the time
over which the LFO will be applied or the time over
which it will continue, etc.
Range: 0–127
Higher settings will produce longer times.
Fade Mode settings
OnI: Specifies the time from when the keyboard is
played until the LFO begins to be applied.
OnO: Specifies the time that the LFO will continue
after the keyboard is played.
OfI: Specifies the time from when the keyboard is
released until the LFO begins to be applied.
OfO: Specifies the time that the LFO will continue
after the keyboard is released.
Refer to the diagrams for Fade Mode.
Fade Time (LFO1/LFO2 Fade Time)
This is the setting page for “Changing the time over
which the maximum (minimum) modulation is
reached (LFO1 Fade Time)” (p. 74).
Offset (LFO1/LFO2 Level Offset)
This parameter offsets the LFO waveform upward or
downward from the central value (pitch or cutoff fre-
quency, etc.).
Range: -100–+100
As this value is increased in the positive (+) direction,
the waveform will be moved upward from the central
value. As this value is increased in the negative (-)
direction, the waveform will be moved downward
from the central value.
fig.5-64 (=MC fig.3-65)
Pitch Depth (LFO1/LFO2 Pitch Depth)
This is the setting page for “Adjusting the depth of
pitch modulation (LFO1 Pitch Depth)” (p. 73).
Filter Depth (LFO1/LFO2 Filter Depth)
This is the setting page for “Adjusting the depth of
cutoff frequency modulation (LFO1 Filter Depth)”
(p. 73).
Amp Depth (LFO1/LFO2 Amplifier
Depth)
This is the setting page for “Adjusting the depth of
volume modulation (LFO1 Amplifier Depth)” (p. 73).
To Next Page
Loading...
