fig.10-5E
3. Hold down [PTN SET] and press BANK [1]
to register the pattern in the pattern set.
4. Use [PART MUTE] and PART [1]–[R] to mute
parts as shown in the diagram.
fig.10-6E
5. Hold down [PTN SET] and press BANK [2]
to register the pattern in the pattern set.
6. Press BANK [1] [2] to select patterns with
different mute settings that are based on
the same single pattern.
Saving a Pattern Set That Was
Modified (Pattern Set Write)
When you have assigned patterns to create a pattern
set that you like, you should save the result as a user
pattern set.
1. Make sure that the pattern is stopped.
2. Press [PTN SET] to access the pattern set
select page.
When you modify the contents of a pattern set, an
asterisk “*” will appear at the left of the number, indi-
cating that the selected pattern set has been modified
(edited). Be aware that if you turn off the power with-
out saving the modified pattern set, the previous set-
tings will reappear.
3. Hold down [SHIFT] and press [WRITE].
The indicator will blink.
The following display will appear, and “ ” (cursor)
will appear at the left of the number.
fig.10-9
If you do not wish to change the number or name, you
can skip steps 4–7.
If you decide not to save the pattern, press [EXIT].
4. Use [INC] [DEC] or the [VALUE] dial to select
the save destination number.
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
At this time, you can press [UNDO/REDO] to check
the name of the pattern set that is currently in the save
destination number. After you have found a pattern
set that you do not mind overwriting, press
[UNDO/REDO] once again to return to the previous
display.
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
5. Press PAGE [>].
The cursor will move to the beginning of the second
line of the display.
fig.0-97-7
6. Assign a name to the pattern set.
Use [INC] [DEC] or the [VALUE] dial to specify the
character.
The following characters are available.
Space, A–Z, a–z, 0–9, ! “ # $ % & ‘ ( ) * +, - . / : ; < = > ?
@ [ ¥ ] ^ _ ` {|}
7. Repeat steps 5–6 to enter the name.
By pressing PAGE [<] you can move the cursor back
toward the left.
8. Press [ENTER].
The confirmation screen will appear in the display.
If you decide to cancel the operation, press [EXIT].
fig.0-97-8
9. Press [ENTER] once again.
fig.0-5
The pattern set write operation will be carried out,
then the normal display will reappear.
The pattern set has now been saved.
To Next Page
Loading...
