Rate [MULTI CTRL 2]
Specifies the rate of modulation.
Range: 0.1–10.0
2MES 3MES 4MES 8MES 16MES
If a note value or measure is selected as the value of
this parameter, the Rate will synchronize with the
tempo of the pattern at intervals of the specified note
value or measure.
Depth [MULTI CTRL 1]
Specifies the depth of modulation.
Range: 0–127
Pre Dly Devi (Pre Delay Deviation)
Adjusts the difference in pre delay between each of the
chorus sounds.
Range: 0–20
Depth Devi (Depth Deviation)
Adjusts the difference in modulation depth between
each of the chorus sounds.
Range: -20–+20
Pan Devi (Pan Deviation)
Adjusts the pan difference between each chorus
sound.
Range: 0–20
As this value is increased, the sound will have a
greater left/right spread.
Balance (Effect Balance)
Specifies the volume balance between the original
sound and the chorus sound.
Range: D100:0E–D0:100E
With a setting of “D100:0E” no chorus sound will be
output.
Output Level [MULTI CTRL 3]
Specifies the output volume from the Tetra Chorus
effect.
Range: 0–127
Flanger (Add Metallic Resonance
to the Sound)
This creates a sharper and more mechanical sound
than the phaser. It can add a metallic resonance to the
sound, or produce an effect that sounds like an jet air-
plane taking off and landing.
fig.7-42 (#MC fig.4-52)
Pre Delay (Pre Delay Time)
Specifies the time from the original sound until the
flanger sound is heard.
Range: 0.0–100
Rate [MULTI CTRL 2]
Specifies the rate of modulation.
Range: 0.1–10.0
2MES 3MES 4MES 8MES 16MES
If a note value or measure is selected as the value of
this parameter, the Rate will synchronize with the
tempo of the pattern at intervals of the specified note
value or measure.
Depth [MULTI CTRL 1]
Specifies the depth of modulation.
Range: 0–127
To Next Page
Loading...
