Roland V-Drums TD-20X - Using the MIX in Jacks as Two Monaural Inputs [F3 (MIX IN)]; Adjusting the Display Contrast [F5 (LCD)]

113
Chapter 9. Settings for the Entire TD-20X [SETUP]
The MIX IN jacks can handle mono or stereo signal.
If it occurs that the audio signal going to the MIX IN jack has a
click on the Right side, and the backing track on the Left side,
you can use this function to merge the signals.
1.
In the “SETUP” screen (p. 108), press the [F4
(OPTION)] button.
2.
Press the [F3 (MIX IN)] button.
The “MIX IN SETTING” screen appears.
fig.09-010-mixin.eps_70
3.
Use the [CURSOR (up/down)] buttons to select the
parameter.
4.
Use the [-] [+] buttons or the [VALUE] dial to make
settings.
5.
Press the [EXIT] button to return to the “SETUP”
screen.
The display contrast is strongly influenced by the location of
the TD-20X and the lighting of the room it’s in. Adjust this
parameter when needed.
1.
In the “SETUP” screen (p. 108), press the [F4
(OPTION)] button.
2.
Press the [F5 (LCD)] button.
The “LCD CONTRAST” screen appears.
fig.09-011-lcd.eps_70
3.
Use the [-] [+] buttons or the [VALUE] dial to adjust.
You can also adjust it by holding the [KIT] button and
turning the [VALUE] dial.
4.
Press the [EXIT] button to return to the “SETUP”
screen.
Using the MIX IN Jacks as Two
Monaural Inputs [F3 (MIX IN)]
Parameter
Value Description
Input
Selects the jack(s) to use as an input.
L + R Use both channels
L ONLY Use only the left channel
R ONLY Use only the right channel
Mode
STEREO
Use as stereo input
MONO Use as monaural x 2
Gain (dB) 0, +6, +12
Adjusts the input level
Adjusting the Display Contrast
[F5 (LCD)]
TD-20X_e.book 113 ページ ２００９年６月８日 月曜日 午後３時５０分