Roland V-Drums TD-20X - Chapter 9. Settings for the Entire TD-20 X [SETUP]; Output Assignments [F2 (OUTPUT)]

108
Chapter 9. Settings for the Entire TD-20X [SETUP]
The “setup” settings apply to the entire TD-20X; they include
the output destination assignments for the TD-20X’s sounds,
and footswitch.
To edit the setup settings, proceed as follows to access the
“SETUP” screen.
1.
Press the [SETUP] button.
The “SETUP” screen will appear.
fig.09-001-setup.eps_70
2.
In the “SETUP” screen, press the [EXIT] button to
return to the “DRUM KIT” screen.
Here is where you can choose how the outputs will function.
You can use the PHONES jack as a monitor output, or the
MASTER OUT to only output the Ambience or Multi Effects or
use DIRECT OUTS 7/8 to output the combined signals of the
DIRECT OUT jacks.
All sounds are always output from the Phones Jack.
1.
From the “SETUP” screen, press the [F2 (OUTPUT)]
button.
One of the following screens will appear.
2.
Use the [F1]–[F4] buttons to select the assignments
you want to make.
3.
Use the [CURSOR (left/right)] buttons to select the
output assignment you want to change.
In the [F1 (MASTER)]–[F3 (DIR 5-8)] button screens, you can
also make a selection by striking a pad or using the TRIG
SELECT buttons.
• [F1 (MASTER)], [F2 (DIR 1-4)], and [F3 (DIR 5-8)] screens
Function button
[F1 (MIDI)]
Make MIDI settings (p. 115).
[F2 (OUTPUT)] Specify the output destination for the sounds
[F3 (CONTROL)]
Assign functions to the footswitch or pads
(p. 110).
[F4 (OPTION)]
Make settings for the preview button, master
comp/EQs, MIX IN jack, and the display (p.
112).
[F5 (F RESET)]
Return the TD-20X to its factory-set state
(p. 114). (Factory Reset)
Output Assignments
[F2 (OUTPUT)]
[F1 (MASTER)] button
fig.09-002-master.eps_70
Output assignments from each pad to the MASTER OUT jacks.
[F2 (DIR 1-4)] button
fig.09-003-dir1.eps_70
Output assignments from each pad to the DIRECT OUT 1–4 jacks.
[F3 (DIR 5-8)] button
fig.09-004-dir2.eps_70
Output assignments from each pad to the DIRECT OUT 5–8 jacks.
[F4 (OTHER)] button
fig.09-005-other.eps_70
Output assignments from ambience and MFX etc. to the MASTER
and DIRECT OUT 5–8 jacks.
[F5 (DEFAULT)] button
When one of the [F1]–[F4] screens are displayed, pressing this
button will return all displayed output assignments to their default
settings (p. 109).
Trigger
input
Indication
Trigger
input
Indication
Trigger
input
Indication
KICK K HI-HAT H AUX 1 A
SNARE S
CRASH 1
C AUX 2 A
TOM1 1
CRASH 2
C AUX 3 A
TOM2 2 RIDE R AUX 4 A
TOM3 3 EDGE E
TOM4 4
TD-20X_e.book 108 ページ ２００９年６月８日 月曜日 午後３時５０分