Roland V-Drums TD-20X - MIDI Channel Settings for the Entire TD-20 X [F2 (GLOBAL)]; Playing an External MIDI Sound Module from Another MIDI Controller (Soft Through)

116
Chapter 10. MIDI Settings
1.
Press the [SETUP] button.
The [SETUP] button lights, and the “SETUP” screen appears.
2.
Press the [F1 (MIDI)] button.
3.
Press the [F2 (GLOBAL)] button.
The “MIDI GLOBAL” screen appears.
fig.10-002-midi-global.eps_70
4. Use the [CURSOR (up/down)] buttons to select the
parameter.
5.
Use the [-] [+] buttons or the [VALUE] dial to make
settings.
6.
Press the [EXIT] button twice to return to the
“DRUM KIT” screen.
This section explains how you can use the Roland SPD-20 (a
MIDI controller) together with the TD-20X’s pads to play
internal sounds and an external sound module.
When “Soft Thru” is set to “ON,” the messages received at
MIDI IN will also be transmitted from the MIDI OUT/THRU
connector.
fig.SoftThru.e
MIDI Channel Settings for the
Entire TD-20X [F2 (GLOBAL)]
Parameter Value Description
Soft Thru
OFF, ON
Soft Through on/off
Local
Control
OFF,
ON (DRUM),
ON (PERC)
Local Switch on/off (p. 117)
Device ID 1–32 Device ID setting (p. 117)
V-LINK
MIDI Ch
CH1–CH16
V-LINK transmit channel (p. 118)
V-LINK
Device ID
1–32, 128
V-LINK device ID (p. 118)
Playing an External MIDI Sound
Module from Another MIDI Controller
(Soft Through)
MIDI IN
MIDI
OUT/THRU
MIDI OUT
SPD-20
Pad or pedal
TRIGGER
INPUT
To the MIDI IN of another
sound module or sampler
TD-20X
TD-20X_e.book 116 ページ ２００９年６月８日 月曜日 午後３時５０分