Roland V-Drums TD-20X - Copying Effect Settings

68
Chapter 4. Effect Settings
Here’s how a drum kit’s ambience settings (AMBIENCE) or
multi-effect settings (MFX) can be copied to another drum kit
in a single operation. You can also copy from a drum kit that’s
in preset memory or on a CompactFlash card.
If you’re copying from user memory, you can exchange the
copy-source and copy-destination settings.
Be aware that when you execute the copy, the contents
of the copy-destination will be overwritten.
1.
Press the [COPY] button.
The [COPY] button will light, and the “COPY A” screen will
appear.
If a CompactFlash card (p. 91) is inserted in the CompactFlash
card slot, the CompactFlash indicator will also light.
2. Press the [F5 (A<>B<>C)] button to access the
“COPY B” screen.
fig.04-013-copy-b.eps_70
3.
Press the [F3 (AMB)] or [F4 (MFX)] button to select
the settings that you want to copy.
(Example: When [F3 (AMB)] is selected)
fig.04-014-copy-amb.eps_70
The screen above can be accessed from the ambience
setting screen (p. 60) or the multi-effects setting screen
(p. 62) by pressing the [COPY] button while you hold
down the [SHIFT] button.
4.
Use the [F1]–[F3] buttons to select the copy-source.
5.
Use the [CURSOR] buttons, [-] [+] buttons, and
[VALUE] dial to specify the copy-source and copy-
destination.
If you selected [F2 (PRESET)] in step 4, specify whether you’re
copying from TD-20 or from TDW-20.
If you selected [F3 (CARD)] in step 4, select the copy-source
backup number.
6.
Press the [F4 (EXCHNG)] or [F5 (COPY)] button.
If you selected [F1 (USER)] in step 4, you can exchange the
copy-source and copy-destination by pressing the [F4
(EXCHNG)] button.
Press the [F5 (COPY)] button to execute the copy.
A confirmation message will appear.
(Example: Copying effect settings from a CompactFlash card)
fig.04-015-copy-amb-conf.eps_70
If you decide to cancel the copy or exchange, press the [F1
(CANCEL)] button.
7.
Press the [F5 (EXECUTE)] button to execute.
The “Send Level” (p. 61) is included in the ambience
settings copied by this operation.
Similarly, the “Send Level” (p. 62) is also included in the
multi-effect settings copied by this operation.
The comp/EQ settings for each pad (instrument) can be
copied as described in “Copying an Instrument” (p. 54).
Copying Effect Settings
Copy source
Copy destination
Function button
[F1 (USER)]
Copy from user memory.
Exchanging the copy-source and copy-
destination is possible only if the copy-source
is user memory.
[F2 (PRESET)]
Copy from preset memory.
You can choose from TDW-20’s preset data or
TD-20 preset data. Select this if you want to
return to the factory-set kit settings.
[F3 (CARD)]
Copy from backup data saved on a
CompactFlash card.
TD-20X_e.book 68 ページ ２００９年６月８日 月曜日 午後３時５０分