Roland V-Drums TD-20X - Deleting a Pattern [F4 (DELETE)]

88
Chapter 6. Recording and Editing Patterns—Sequencer
4.
Use the [-] [+] buttons or the [VALUE] dial to select
the pattern, part, and measures.
5.
Press the [F5 (ERASE)] button.
The confirmation screen appears.
fig.06-16-ptn-erase-conf.eps_70
To cancel, press the [F1 (CANCEL)] button.
6.
Press the [F5 (EXECUTE)] button.
This deletes the pattern performance, beat, measure length,
part, and all other settings, creating a empty pattern.
fig.07-Del1
You can delete unneeded measures from the pattern, then
connects the portions before and after the resulting gap.
fig.07-Del2
• The performance data following the deleted range is
moved forward (and the performance data for that part
is shortened).
• When all parts in the targeted range are specified,
deletion results in the pattern itself becoming shorter.
• When all measures for all parts are deleted, the pattern
itself is deleted, resulting in a pattern containing no
performance data (an empty pattern). Settings,
including beat and measure length, are restored to their
initial values as well.
1.
In the “PATTERN EDIT” screen (p. 85), press the [F4
(DELETE)] button.
The “PATTERN DELETE” screen appears.
fig.06-17-ptn-delete.eps_70
2. When you want to delete selected measures, press
the [F4 (MEASURE)] button.
The “PATTERN DELETE MEASURE” screen appears.
fig.06-18-ptn-delete-meas.eps_70
3.
Use the [CURSOR (left/right)] buttons to select the
parameter.
4. Use the [-] [+] buttons or the [VALUE] dial to select
the pattern and measures.
5.
Press the [F5 (DELETE)] button.
The confirmation screen appears.
fig.06-19-ptn-delete-conf.eps_70
To cancel, press the [F1 (CANCEL)] button.
6.
Press the [F5 (EXECUTE)] button.
Pattern
Part Measure
Pattern to be
erased
Part to be
erased
Measures to be erased
(first measure–last measure)
Deleting a Pattern [F4 (DELETE)]
12 643785
1
12 643785
123
7
78
Pattern
Measure
Pattern to be deleted
Measures to be deleted
(first measure–last measure)
TD-20X_e.book 88 ページ ２００９年６月８日 月曜日 午後３時５０分