65
Chapter 4. Effect Settings
LO-FI
Intentionally degrades the sound quality for creative
purposes.
RING MOD
Applies amplitude modulation (AM) to the input signal,
producing bell-like sounds.
You can make settings for the stereo compressor/limiter and
three-band parametric EQ (equalizer) that are applied to the
final stage of the master output. These settings can be used
for individual kits and/or all kits.
Using the master compressor
• When used as a compressor, this allows you to raise the
overall loudness of the drums by compressing brief peaks in
the sound. This lets the sound project better, without being
buried in the mix by the other instruments.
• When used as a comp-limiter, this lets you increase the
recording level while limiting the maximum input to the
recording device.
• If you’re using a small monitor amp, you can use this effect as
a limiter so that the peaks of the drum sound are limited,
making the sound less likely to distort.
Using the master EQ
• This lets you adjust the tonal character by boosting or cutting
each of the three bands (low, mid, and high-frequencies).
• You can also use this to make compensations in the tone
when using the master comp.
1.
Press the [MASTER COMP/EQ] button.
The [MASTER COMP/EQ] button will light.
2.
Press the [F1] button to turn the MASTER COMP/EQ
on/off.
This is the same setting as turning MASTER COMP/EQ on/off
in the “EFFECTS SWITCH” screen (p. 58).
Parameter
Value Description
Fs Rate
OFF, 1/2–1/32
Sample rate
Bit
OFF, 15–1
Number of bits in data
BPF Cutoff
0–100
Cutoff frequency of the BPF
(Band Pass Filter)
BPF Mix
0–127
Amount of mixing the sound
that goes through the BPF
Parameter
Value Description
Freq
0–127
Frequency at which
modulation is applied
Adjusting the Overall Sound
[MASTER COMP/EQ]
Using the Master Comp/EQ
Turning the Master Comp/EQ Switch
On/Off
TD-20X_e.book 65 ページ ２００９年６月８日 月曜日 午後３時５０分
To Next Page
Loading...
