Roland V-Drums TD-20X - Deleting Data from a Compactflash Card [F4 (DELETE)]; Formatting a Compactflash Card [F1 (FORMAT)]

94
Chapter 7. Using CompactFlash Cards [CARD]
You can delete the unneeded data from a CompactFlash
card.
1.
Insert the CompactFlash card into the
CompactFlash card slot on the TD-20X’s front
panel.
2.
Press the [CARD] button.
The [CARD] button and the CompactFlash indicator light, and
the “CARD A” screen appears.
3.
Press the [F4 (DELETE)] button.
The “CARD DELETE” screen appears.
fig.07-010-card-delete.eps_70
4.
Use the [-] [+] buttons or the [VALUE] dial to select
the backup area containing the unneeded data.
5.
Press the [F5 (DELETE)] button.
The confirmation screen appears.
fig.07-011-card-delete-conf.eps_70
To cancel, press the [F1 (CANCEL)] button.
6.
Press the [F5 (EXECUTE)] button to delete the
backup.
When a card is being used for the first time by the TD-20X,
you must execute the following procedure to initialize the
card.
• When a card is initialized, all data on that card will be
lost. Make sure that it does not contain data you wish to
keep.
• If a CompactFlash card of larger than 2GB capacity is
formatted on the TD-20X, it will be formatted to 2GB.
1.
Insert a CompactFlash card into the CompactFlash
card slot on the TD-20X’s front panel.
2.
Press the [CARD] button.
The [CARD] button and the CompactFlash indicator light, and
the “CARD A” screen appears.
3.
Press the [F5 (A<>B)] button to access the “CARD B”
screen.
fig.07-012-card-b.eps_70
4. Press the [F1 (FORMAT)] button.
The “CARD FORMAT” screen appears.
fig.07-013-card-format.eps_70
5.
Press the [F5 (FORMAT)] button.
The confirmation screen appears.
fig.07-014-card-format-conf.eps_70
To cancel, press the [F1 (CANCEL)] button.
6.
Press the [F5 (EXECUTE)] button again to start
formatting.
Deleting Data from a
CompactFlash Card [F4 (DELETE)]
Formatting a CompactFlash
Card [F1 (FORMAT)]
TD-20X_e.book 94 ページ ２００９年６月８日 月曜日 午後３時５０分