Roland V-Drums TD-20X - Restoring the Factory Settings [F5 (F RESET)]

114
Chapter 9. Settings for the Entire TD-20X [SETUP]
This restores the TD-20X to the original factory settings
(Factory Reset).
All data and settings stored in the TD-20X are lost in
carrying out this operation. So if necessary, save your
data to a CompactFlash card or an external MIDI device
before executing the factory reset (p. 92, p. 119).
1.
Press the [SETUP] button.
2.
Press the [F5 (F RESET)] button.
The “FACTORY RESET” screen appears.
fig.09-012-freset.eps_70
3.
Press the [F5 (F RESET)] button.
The confirmation screen appears.
fig.09-013-freset-conf.eps_70
To cancel, press the [F1 (CANCEL)] button.
4. Press the [F5 (EXECUTE)] button to execute Factory
Reset.
When Factory Reset is finished, the following screen appears.
fig.09-014-vh-offset.eps_70
If you do not want to adjust the “VH Offset” parameter, press
the [F1 (CANCEL)] button.
The offset adjustment is necessary in order to correctly
detect open/close and pedal movements.
5.
Press the [F5 (ADJUST)] button.
The “VH OFFSET ADJUSTMENT” screen appears.
fig.09-015-vh-offset2.eps_70
6.
Loosen the clutch screw of the top hi-hat and let it
sit on the bottom hi-hat.
Do NOT touch the hi-hats or the pedal.
7.
Press the [F5 (EXECUTE)] button.
The “VH Offset” parameter is set automatically.
fig.09-016-vh-offset3.eps_70
When finished, the “DRUM KIT” screen appears.
When Factory Reset is carried out, the GROUP FADERS
settings values are set to the maximum volume,
regardless of the slider positions.
Restoring the Factory Settings
[F5 (F RESET)]
TD-20X_e.book 114 ページ ２００９年６月８日 月曜日 午後３時５０分