Roland V-Drums TD-20X - Setting the Volume and Pan of each Part [F4 (MIXER)]

76
Chapter 5. Playing Patterns—Sequencer
5.
Use the [CURSOR], [-] [+] buttons, and [VALUE] dial
to specify the copy-source and copy-destination.
If you selected [F3 (CARD)] in step 4, select the copy-source
backup number.
6.
Press the [F4 (EXCHNG)] or [F5 (COPY)] button.
If you selected [F1 (USER)] in step 4, you can exchange the
copy-source and copy-destination by pressing the [F4
(EXCHNG)] button.
Press the [F5 (COPY)] button to execute the copy.
A confirmation message will appear.
(Example: Copying settings from a CompactFlash card)
fig.05-020-perc-copy-conf.eps_70
If you decide to cancel the copy or exchange, press the [F1
(CANCEL)] button.
7.
Press the [F5 (EXECUTE)] button to execute.
• Drum part cannot be set here. Set in the MIXER settings
(p. 56).
• To adjust volume/pan settings for each instrument of
the percussion part, refer to p. 73.
1. In the “PATTERN PART” screen (p. 71), press the [F4
(MIXER)] button.
The “PART VOLUME”, “PART PAN”, “PART REVERB SEND
LEVEL”, or “PART CHORUS SEND LEVEL” screen appears.
fig.05-021-part-vol.eps_70
2.
Press the [F1]–[F4] buttons to select the parameter.
3.
Use the [CURSOR (left/right)] buttons to select the
part you wish to set.
4.
Use the [VALUE] dial, the [-] [+], or [CURSOR (up/
down)] buttons to make settings.
5.
Press the [EXIT] button to return to the “PATTERN
PART” screen.
Setting the Volume and Pan of Each
Part [F4 (MIXER)]
Parameter
Value Description
[F1 (VOLUME)] button
PART
VOLUME
0–127
Volume of each part
The percussion part (PERC)
specifies the volume of the
entire part.
[F2 (PAN)] button
PART PAN
L15–CTR–R15 Panning of each part
[F3 (REV SND)] button
PART
REVERB
SEND LEVEL
0–127 Reverb depth of each part
[F4 (CHO SND)] button
PART
CHORUS
SEND LEVEL
0–127 Chorus depth of each part
TD-20X_e.book 76 ページ ２００９年６月８日 月曜日 午後３時５０分