Roland V-Drums TD-20X - Copying a Set of Multiple Instruments

55
Chapter 2. Instrument Settings [INST]
4.
Use the [CURSOR] buttons, [-] [+] buttons, and
[VALUE] dial to specify the copy-source and copy-
destination.
If you selected [F2 (PRESET)] in step 3, specify whether you’re
copying from TD-20 or from TDW-20.
If you selected [F3 (CARD)] in step 3, select the copy-source
backup number.
5. Use the [CURSOR] buttons, [-] [+] buttons, and
[VALUE] dial to select the copied content (Copy
Target).
6.
Press the [F4 (EXCHNG)] or [F5 (COPY)] button.
If you selected [F1 (USER)] in step 3, you can exchange the
copy-source and copy-destination by pressing the [F4
(EXCHNG)] button.
Press the [F5 (COPY)] button to execute the copy.
A confirmation message will appear.
(Example: Copying an instrument from a CompactFlash card)
fig.02-037-inst-copy-conf.eps_70
If you decide to cancel the copy or exchange, press the [F1
(CANCEL)] button.
7.
Press the [F5 (EXECUTE)] button to execute.
You can copy multiple instruments to another drum kit in a
single operation.
Proceed as described in “Copying an instrument,” but do the
following in steps 2 and 4.
In step 2 , choose [F3 (INST SET)].
In step 4 , move the cursor to the far right of the copy-source,
and select the instrument set that you want to copy.
Value
Description
with Pad
Comp/EQ
The pad’s instrument settings (Instrument, V-
Edit), Pad Compressor, and Pad EQ settings (p.
59) will be copied.
Inst V-Edit
Only
Only the pad’s instrument settings
(Instrument, V-Edit) will be copied.
Pad Comp/EQ
Only
Only the Pad Compressor and Pad EQ settings
(p. 59) will be copied.
Copying a Set of Multiple Instruments
Value Description
KICK/SNR
Copy Kick and Snare.
TOMS 1–4 Copy Tom 1, 2, 3, and 4.
CYM SET Copy Hi-Hat, Crash1, 2, Ride, and Edge.
AUX 1–4 Copy AUX 1, 2, 3, and 4.
TD-20X_e.book 55 ページ ２００９年６月８日 月曜日 午後３時５０分