52
Chapter 2. Instrument Settings [INST]
1.
Press the [INST] button.
2.
Press the [F3 (CONTROL)] button.
3.
Select the pad that you want to edit.
Strike the desired pad, or use the TRIG SELECT buttons to
select it.
The edit screen for the selected pad will appear.
4.
Press the [F1]–[F5] and [CURSOR (up/down)]
buttons to select the parameter.
5.
Use the [-] [+] buttons or the [VALUE] dial to adjust
settings.
6.
When finished, press the [EXIT] button to return to
the “INST” screen.
The Pad Pattern function starts playback of a pattern when a
pad is struck. This function provides a very convenient way to
use patterns during a live performance.
If different patterns have been assigned to two or more pads,
striking another pad while a pattern is playing back will cause
pattern playback to switch to the newly selected pattern.
fig.02-029-padptn.eps_70
The performance of a pattern played back by the Pad
Pattern function cannot be recorded into the sequencer.
For more about patterns, refer to “Chapter 5. Playing
Patterns—Sequencer” (p. 69).
fig.02-030-pedal.eps_70
Using Pads/Pedal as Controllers
[F3 (CONTROL)]
Playing a Pattern by Hitting a Pad
(Pad Pattern) [F1 (PATTERN)]
Parameter
Value Description
PadPtn
Master Sw
OFF, ON
Specifies whether the Pad Pattern
function will be used (ON) or not
used (OFF).
Pad Ptn
OFF,
P 1–150,
U 101–
200
Selects the played back pattern
when the pad is struck.
If all pads are set to “OFF,”
icon
appears.
Pad Ptn
Velocity
OFF
The pattern plays back at the velocity
set for the pattern, regardless of the
strength with which the pad is struck.
ON
The pattern plays back with the
velocity changing in response to the
strength with which the pad is struck.
Tap Ptn
Mute Grp
OFF, 1–8
This setting is valid only if “TAP” (p.
78) has been selected as the “Play
Type” for a multiple number of pads.
If one sound (pattern) is set to play
before the previous sound (pattern)
has finished playing, this setting
allows you to either have the
previous sound stop and the
subsequent sound start playing or
have the two sounds layered.
•
Patterns set to the same
number
The previous sound stops while in
progress, and the subsequent
sound (pattern) starts playing.
•
Patterns set to the different
numbers
The previous sound continues to
play to the end, while the
subsequent sound (pattern) is
superimposed on it.
Using the Hi-Hat Pedal to Change an
Instrument’s Pitch [F2 (PDLBEND)]
Parameter
Value Description
Pedal Bend Range
-24–0–+24
Specifies the amount of
pitch change produced by
the hi-hat pedal.
You can set this for each
pad (head and rim
separately) in semitone
units.
TD-20X_e.book 52 ページ ２００９年６月８日 月曜日 午後３時５０分
To Next Page
Loading...
